What are the factors affecting the operation of the cone crusher?

Cone crusher iron have means to prevent the crushing chamber through the iron, the iron if too frequently, it may cause breaking accident. To be fully loaded, otherwise the product size will be too thick. The crushing ratio in the production line should be reasonable, so as to maximize the efficiency of the crusher . The spring pressure should not be too tight. If the pressure is too high, the shaft breakage will occur. If the pressure is too small, the spring will jump frequently, affecting the normal operation of the crusher, and the product size will become thicker. The temperature of the lubricating oil should not be too high or too low, otherwise it will affect the operation of the machine. Lubricating oil should be replaced frequently, not too dirty. If it is too dirty, it will accelerate the wear of gears, bowl-shaped tiles, bushings, etc., and even kill the bushing. The drive belt installation should not be too tight, otherwise it will cause the drive shaft to rotate inflexibly or break. Also not too loose, otherwise it will cause the crusher to suffocate. Cone crusher feed can not be too wet and too sticky, fine particles can not be too much, can not be too large, otherwise it will cause boring. Accumulation of the discharge at the discharge of the crusher will also cause a boring car.

Due to the harsh environment and large dust, the cone crusher often has some problems in the maintenance of the unit. In general, the conical crusher should pay attention to the following problems during operation. In order to ensure the normal operation of the machine.

Cone stone breaking machine is working, the feeding should be even and can not be segregated. If the feeding is uneven, the production capacity will decrease, the product size will be too large, the spring action will be frequent, the bowl bearing pressure will be large, and the power consumption will increase.

For each certain period of time, it is best to properly inspect and repair the equipment, which will keep the equipment in a better operating state after continuous production, and obtain better production capacity and finished product quality. The minor repair cycle is carried out every half month to one month. The contents include: checking the wear of the bowl tile, the taper sleeve and the straight sleeve and checking the gap, the bevel gear meshing clearance and the transmission bushing clearance.

The above is the details that need to be paid attention to when using the cone crusher, and it is also a matter to ensure that the cone can be operated normally.

Heat Exchanger Accessories

Heat Exchanger Accessories is a wide area.It has many parts.We are mainly strong in the air conditioning parts such as radiator,condenser,evaporator,inter cooler,oil cooler,charge air cooler parts in the gas car.Also Trumony is strong in new energy car battery cooling parts,such as heat pipe,brazing water cooling plate,extruded water cooling plate or roll bond water cooling plate.We can also offer engineering solution for the design of the battery cooling unit if you want.A detailed technic communication is very important to understand about your requirement.Bring technology to the ground is the target we are always persuing.Trust in harmony,we care what our clients care.

Heat Exchanger Accessories,Extruded Aluminum Bar,Aluminum Extrusion Bar,Structural Aluminum Profiles,Heat Exchanger Accessories

Trumony Aluminum Limited , http://www.szaluminumpipe.com